Gun Paint Planner·Updated September 28, 2026
Rattle Can Diamond M24 Paint Job (Black Ops 2 Camo)
Light blue and blue shards over white with bright flecks on an M24 sniper rifle (Remington 700). The look comes from Black Ops 2. The pattern is painted on the gun below with real spray can colors; reroll it, change brands, or paint over it by hand.
Diamond on an M24, on a real photo
Reroll the layout, switch paint brands, or paint over it by hand. Render saves a picture with shadows, Share gives you a link.
Photo: M24 photo by the US Air Force, Public domain
Community
Rattlecanned guns leaderboard
Paint jobs people made in the planner. Vote the best up, or submit your own.
Where the Diamond camo comes from
Diamond is the Black Ops 2 camo for getting Gold on every gun in a class. It started the Diamond tier Treyarch has used ever since. The full Diamond story and every gun painted in it
Spray cans for a diamond M24
In spray order, lightest first. Either brand works; do not mix them in one job.
Krylon
- 1COLORmaxx Flat White
- 2COLORmaxx Gloss Blue Ocean Breeze
- 3COLORmaxx Gloss True Blue
Rust-Oleum
- 1Painter's Touch 2X Flat White
- 2Painter's Touch 2X Gloss Spa Blue
- 3Painter's Touch 2X Gloss Deep Blue
How to spray diamond on an M24
1. Strip it down
Pull the bolt, take the barreled action out of the stock, and take the scope off or bag it. The stock and the barreled action paint best apart.
2. Degrease everything
Wipe every outside surface with acetone or isopropyl alcohol. Paint will not hold over gun oil.
3. Mask what moves
Plug the chamber and muzzle, tape the bolt raceway, the magazine well, the trigger and the scope lenses and turrets. Leave the inletting where the action sits bare.
4. Base coat in white
Two light coats over the whole gun, 8 to 12 inches away, 10 minutes apart.
5. Blue ocean breeze through a splinter stencil
Lay a splinter stencil sheet on the gun and spray blue ocean breeze through it.
6. True blue through a splinter stencil
Lay a splinter stencil sheet on the gun and spray true blue through it.
7. White specks
Flick small specks of white: a short burst from a foot away, or a stiff brush dipped in paint.
8. Let it cure
Handle it after an hour but give it a full day before it goes in a case, and a few days before hard use.
More M24 paint ideas and paint jobs
- Tiger stripe M24
- M81 woodland M24
- Chocolate chip M24
- Snakeskin bands M24
- OD green, tan mag M24
- Desert blotch M24
- Multi-terrain M24
- Flecktarn dots M24
- Digital woodland M24
- Splinter M24
- Two tone M24
- Red Tiger M24
- Blue Tiger M24
- Golden M24
- Arctic M24
- Fall M24
- Dragon M24
- Dark Matter M24
- Damascus M24
- Asiimov M24
- Redline M24
- Fade M24
- Hyper Beast M24
- Galaxy M24
- Hot Rod Flames M24
- All M24 ideas
Diamond on other guns
Frequently Asked Questions
What spray paint do you need for a diamond M24?
3 cans, sprayed in this order: Krylon Flat White, Gloss Blue Ocean Breeze, Gloss True Blue; or Rust-Oleum Flat White, Gloss Spa Blue, Gloss Deep Blue.
Can you rattle can diamond on an M24 yourself?
Yes. Strip and degrease the M24, mask what moves, lay the lightest color first and build the pattern light to dark with tape, stencils or netting. Plan on an afternoon plus a day to cure.
Cite this tool: GunPartPicker, “Rattle Can Diamond M24 Paint Job (Black Ops 2 Camo)”, https://gunpartpicker.net/gun-paint-planner/m24/diamond. Paint colors from the Krylon and Rust-Oleum color charts; gun photos credited under each gun. Free to cite with attribution.
Read next
All guides →
More Gun Tools
- PlanningAR Build Cost CalculatorHow much does it cost to build an AR-15? Pick caliber, barrel length, stock or brace and optic, then drag both edges of the price band from the cheap end to the top end. Every slot fills with the part builders add most that is in stock, priced live. The headline total is the core rifle, optics and extras are priced separately, and beside them sits what builders really pay per slot, measured from real part picks. Roll a random build, or open yours in the builder in one click. Computed from over 1 million AR parts selected on GunPartPicker since 2020.
- CompatibilityGlock Size ComparisonPick any two Glocks and see them to scale as real photos sized to Glock's published dimensions, side by side, from behind and as an X-ray, with the difference in length, height, width and weight in one line and the pistols in stock for each.
- LegalGun Travel CheckerCan I bring my gun to another state? Pick where you start, where you are going and what is coming along: carry pistol, AR-15, magazines, suppressor, SBR, brace, forced reset or binary trigger, hollow points. Every state on the route is checked for transporting firearms across state lines: magazine limits, assault weapon bans, NFA rules, carry permit type and trigger bans, with what to do before the state line.
- CompatibilityMuzzle Thread CheckerPick your barrel's caliber and platform, get the standard thread pitch, and see every muzzle device and suppressor in the catalog that actually threads on, with live prices.
- CompatibilitySuppressor Mounts (3D)Put a can on its mount in 3D. Compare SilencerCo ASR, Dead Air KeyMo, SureFire Fast-Attach, HUXWRX QD, HUB 1.375x24 and direct thread: what goes on the barrel, what is on the can, how it locks and which cans fit which mounts. Cut it open to see the taper and the baffles, then shop the mounts and cans in stock.
- CompatibilityDI vs Piston (3D)Watch a direct impingement AR-15 and a gas piston HK416 fire in slow motion x-ray 3D. Follow the gas from the port back into the carrier, or into a piston that kicks an op rod, see which bolt runs hot, and compare weight, cleaning, suppressed use, carrier tilt and cost.
- CompatibilityUpper vs Lower Receiver (3D)Take a real AR-15 apart in 3D and see how the upper and lower receiver go together. Push the takedown pin, hinge the upper open on the pivot pin, pull the bolt carrier group and lift the upper off, with every part colored by the half it belongs to.
- CompatibilityHow Muzzle Devices Work (3D)Watch one shot leave an AR-15 muzzle in slow motion 3D through a bare barrel, a flash hider, a compensator, a muzzle brake and a linear comp. See where each sends the gas, and what that does to flash, recoil, muzzle rise and the blast beside you.
- CompatibilityHow a BCG Works (3D)Watch an AR-15 bolt carrier group unlock, extract and lock again in slow motion 3D, then take it apart part by part. See the cam pin turn the bolt out of the barrel extension, and what each part does.
- CompatibilityBuffer Tube and Stock (3D)See an AR-15 buffer tube, end plate, castle nut and stock go on in 3D, walk the stock through its six positions, and put a mil spec and a commercial tube side by side to see why a stock only fits one of them.
- CompatibilityHow a Charging Handle Works (3D)Watch an AR-15 charging handle unlatch and pull the bolt carrier back by its gas key in 3D, then watch the rifle fire while the handle stays put. Compare a standard latch with an ambidextrous one.
- CompatibilityHow the Gas System Works (3D)Watch a shot's gas go up an AR-15's gas port, through the gas block and back down the gas tube to the bolt carrier in slow motion 3D. Turn it down with an adjustable gas block, and see where the port sits on pistol, carbine, mid length and rifle gas.
- CompatibilityFree Float vs Drop In Handguard (3D)Watch an AR-15 free float handguard go on its barrel nut in 3D, lean on a free float and a drop in handguard to see which one moves the barrel, and lock an M-LOK rail section in. Plus M-LOK vs KeyMod and what length fits your barrel.
- CompatibilityHow Triggers Work (3D)Watch a standard trigger, a forced reset trigger and a binary trigger run inside an x-ray AR-15 in slow motion 3D. See the hammer, the disconnector, the FRT's locking bar and the bolt carrier at every step, and what each one needs and where it is legal.
- CompatibilityFRT and Binary Trigger PickerChoose your platform and see every forced reset trigger, binary trigger and Super Safety the catalog carries for it, what the host needs to run one, and where each is in stock.
- CompatibilityGlock Red Dot Fit CheckerPick how your Glock slide is cut and see which red dots mount directly, which need a plate, and the plates and optics in stock right now.
- CompatibilityP385 Size ComparisonSee the SIG P385 CARRY, COMP and FULL to scale against the P365-XMACRO, the P320 and the Glock 19, 17, 45 and 43X, as real photos sized to the published length and height, with every dimension and where to order one.
- TuningTwist Rate CalculatorPick a bullet and a twist rate, get the Miller stability factor, then see barrels with that twist and ammo loaded with that bullet, with today's price per round.
- TuningOptic Zero (3D)See where a 25, 36, 50, 100 or 200 yard zero hits on a 3D range, with your ammo, barrel length and optic height. Compare two zeros side by side, look through your red dot, EOTech or LPVO at each distance, then tap where your group hit and get the exact clicks up, down, left and right for your optic.
- TuningBuffer Weight CalculatorEnter your gas system, barrel length, buffer tube and ammo, add a suppressor or a fast trigger, and get the buffer weight to start with plus the buffers in stock that match.
- TuningBuffer System (3D)Watch an AR-15 cycle in slow motion, cut open: gas drives the bolt carrier back, the bolt unlocks and throws the brass, the buffer and spring soak it up and send it home. Swap carbine, H, H2 and H3 buffers, add gas or a suppressor, and see the carrier speed, where the brass lands and when it short strokes.
- LegalBarrel and Overall Length CheckerEnter barrel length, muzzle device and how the back end is configured, and see whether the build is a rifle, a short barreled rifle, a pistol or an AOW under federal law, with the barrels in stock at that length.
- LegalSBR Planner (3D)Set the barrel anywhere from 7.5 to 16 inches, put a stock, a brace or a folder on the back, pin a muzzle device or slide on a can. The ruler under the rifle shows whether you've cleared the 16 inch barrel line and the 26 inch overall line. Pick your state for its SBR, suppressor and assault weapon rules, then price every part and open the build in one click.
- PlanningNight VisionLook around a real 360 degree scene through Gen 1, Gen 2+, Gen 3 green and white phosphor tubes, digital night vision and thermal. Turn the moon down from full to overcast, switch on an IR light, compare two devices side by side. Or walk a 3D farm at night and spot the people, hogs and deer hiding in it. Then see the PVS-14, PVS-31, GPNVG-18 and the thermal scopes people buy, with prices.